Product description
3004 aluminium foil at 0.2 mm in H16 is the heaviest section in the foil range, supplied 1200 mm wide on 76 mm or 152 mm cores.
At this gauge a part is rarely shaped in a press. It is cut, bent once in assembly and then left alone, and the questions that matter change accordingly: whether the section stays straight after the bend, whether the flat blank arrives flat, and whether the edge can be handled without a burr opening into a crack.
3004 carries manganese, so the strength is in the alloy rather than only in the work hardening. That is what makes a heavy section practical: the part does not depend on the forming operation to become stiff, so a single bend does not decide the whole component.
H16 leaves room for that bend. A fully hard temper at this gauge will hold a flatter section but recover more after the bend, and the assembly then fights a tolerance the tool cannot fix. H16 trades a little stiffness for a predictable bend, which is the right trade when the bend is the only forming step.
Flatness is the property to specify, because at 0.2 mm a coil with a set will not be pulled straight by any reasonable tension. The gauge is also heavy enough that a coil needs equipment to lift and to load, and the cut edge is substantial enough that edge quality is visible on the finished part rather than hidden in a laminate.
Typical uses include stiff brackets, flat structural panels, duct connectors and reinforcing sections.
Minimum order quantity is 3 MT per size, and loading is from Qingdao, Tianjin or Shanghai. Send the blank drawing, the bend and the flatness the assembly needs, and we will confirm the specification that fits.